I cut some parts like this for welding. I don't know whether this way is better. To know that, I have using this.
Next, I welded steering pivot. To keep the hole, I used brass round bar.
Then the steering pivot and the rectangular tube were welded.
This time I can check my welding from inside.
The back side was sanded to get flat.
They were put along the drawing then tacked.
I tried to change the voltage. From left to center, high power. From right to center low power. This part had 90 degrees angle and one side is edge and the other is surface. In this case, high voltage is better.
We can see the form like fork.
Today's last shot.
I can't leave beautiful bead yet.
Next, I welded steering pivot. To keep the hole, I used brass round bar.
Then the steering pivot and the rectangular tube were welded.
This time I can check my welding from inside.
The back side was sanded to get flat.
They were put along the drawing then tacked.
I tried to change the voltage. From left to center, high power. From right to center low power. This part had 90 degrees angle and one side is edge and the other is surface. In this case, high voltage is better.
We can see the form like fork.
Today's last shot.
I can't leave beautiful bead yet.
