I used same method to make stays. First tacking.
Drilling and cutting, sanding.
Voila.
They were installed.
I covered each columns for seat.
Then, bar to attach front deraileur. The angle 63-66 degrees.
Checked on front view.
Welded.
Next I welded some pipes to make stay for fender.
Drilling and cutting, sanding.
Voila.
They were installed.
I covered each columns for seat.
Then, bar to attach front deraileur. The angle 63-66 degrees.
Checked on front view.
Welded.
Next I welded some pipes to make stay for fender.
