At first, I made a reflector for back. I cut iron sheet and bent it and drilled for screw.
Next, I made two handle for carrying this bike.
I cut out side pipes from the old handle. For pieces of iron sheet, too.
Then tacked like this on the stay for fenders.
After checking the balance, angle, welded.
This is for rear,
This is for front.
I made stay to put on smart phone and light.
I tapped 10 mm tube with M8 tap. Then, I drilled the side of the tube and welded 22 mm tube and the 10 mm tube.
M8 screw was installed in the 10 mm's, then welded through the hole on the side.
This is attached on the tube for front deraileur.
I made smaller part to attach a sensor for cadence.
Today's last shot.
